Mechanical Unit Support LD

To obtain pricing for the mechanical supports, have the following information available:
1. Width and Length desired
2. Height off roof
3. Weight of unit being supported


Drawing Spec
  • 24x24x7 Spec & Drawing Sheets (PDF)
  • 30x30x7 Spec & Drawing Sheets (PDF)
  • 36x36x7 Spec & Drawing Sheets (PDF)
  • DWG Drawing
  • LD 24x24x7 Drawings (DWG)
  • LD 30x30x7 Drawings (DWG)
  • LD 36x36x7 Drawings (DWG)
  • SKU: LD-Mech_support Category:


    MIRO Mechanical Unit Supports are designed to elevate rooftop mechanical units such as air conditioning or other devices. The Mechanical Unit Supports are designed so that the mechanical units rest in heavy-duty corner or side supports which are connected to bases designed with MIRO technology to protect the roof membrane. The Mechanical Unit Supports are adjustable in that the strut can be selected to the appropriate height and there is provided an additional threaded rod which allows fine adjustment to level the roof-top units. The MIRO Mechanical Unit Support consists of  designed bases with curved edges to protect the roof membrane and to distribute the weight over the maximum roof surface. The all-thread allows for height adjust-ability.

    Base Material: Polycarbonate
    Size: Mechanical Unit Supports come in 24″ x24″, 30″ x30″ and 36″ x36″.
    Max Load Weight: Maximum load weight is equivalent to and is part of the maximum roof top bearing load which MIRO has designed for its bases. MIRO recommends such loading not exceed two pounds per square inch.
    Spacing: The Mechanical Unit Support should be spaced at intervals so as to allow proper installation of the mechanical units or devices.